Technical Specifications
Horizontal axis wire drawing machine with integrated dancer. Non-slip wire drawing machine for metal wires, especially carbon steel wires. 10-roll, pre-set for quick assembly of the complete set of pre-installed rolls.
Three horizontal axis, standard tungsten carbide coated ring wire drawing system.
The Miller is mounted in a watertight chamber: guaranteeing the perfect seal of the draw-out bath.
Toothed belt drive. All rollers are rotary.
Lubricating/cooling fluid circulation is provided by a pump and a heat exchanger.
The pull head is ceramic coated.
Technical specifications
Maximum input wire diameter 2.4 mm
Minimum output wire diameter 0.8 mm
Redüksiyon %16,6
Maximum pulling speed: 15 m/s
Maximum number of pulling steps in wet machine: 10
Installed power 75 kW
Engine cooling is via air.
Number of shafts: 3
Heat exchanger included.
Emulsion circulation pump included.
Inlet mold holder included.
Surface treatment of tensile rings: tungsten carbide
Final surface treatment: Tungsten carbide
The end mold holder is a rotary system with quick mold change.
MAIN BODY:
It is made of electro-welded sheet steel and has three main compartments: a motor and
the transmission compartment, a coolant compartment, and a third towing compartment
